dead centre w słowniku Oxford-Hachette French Dictionary

Tłumaczenia dla hasła dead centre w angielski»francuski słowniku

1. dead (no longer living):

drop dead pot.!
va te faire voir! pot.
dead and buried dosł., przen.

III.dead [Brit dɛd, Am dɛd] PRZYSŁ. (absolutely, completely)

dead esp Brit
it's dead easy pot.!
dead drunk pot.
dead tired pot.
crevé pot.
dead tired pot.
claqué pot.
I was dead scared pot.!
génial! pot.
you're dead on pot.! Am

center → centre

Zobacz też centre

I.centre Brit, center Am [Brit ˈsɛntə, Am ˈsɛn(t)ər] RZ.

II.centre Brit, center Am [Brit ˈsɛntə, Am ˈsɛn(t)ər] CZ. cz. przech., cz. nieprzech.

I.centre Brit, center Am [Brit ˈsɛntə, Am ˈsɛn(t)ər] RZ.

II.centre Brit, center Am [Brit ˈsɛntə, Am ˈsɛn(t)ər] CZ. cz. przech., cz. nieprzech.

Zobacz też left

I.left [Brit lɛft, Am lɛft] CZ. I f. cz. przesz. CZ. im. cz. przeszł.

left → leave

dead centre w słowniku PONS

Tłumaczenia dla hasła dead centre w angielski»francuski słowniku

American English

Przykłady jednojęzyczne (niezredagowane i niesprawdzone przez PONS)

angielski
The advantage of the design should have been very early (0-5 degrees before top dead centre) opening inlet valve.
en.wikipedia.org
Small steam barring engines were also used to move the engine away from dead centre before starting.
en.wikipedia.org
In a multi-cylinder engine, pistons may reach top dead centre simultaneously or at different times depending on the engine configuration.
en.wikipedia.org
Not only did this provide maximum tractive effort when starting but also avoided problems that might arise if the high pressure piston was in a dead centre position.
en.wikipedia.org
Instead, it uses a crossplane crankshaft that prevents the pistons from simultaneously reaching top dead centre.
en.wikipedia.org
Therefore, if both cranksets could be at dead centre at the same time, and the wheels should happen to stop in this position, the locomotive could not be started moving.
en.wikipedia.org
The steering loads up sharply off the dead centre, which is just where you need to "feel" a vehicle such as this into a corner.
www.telegraph.co.uk
That is; about 120 degrees after bottom dead centre.
en.wikipedia.org
A parallel twin with this many cylinders would be self-starting from dead centre anyway (assuming the usual crankshaft with cranks at 90).
en.wikipedia.org
Its timing is such that the fuel is injected only very slightly before top dead centre of that cylinder's compression stroke.
en.wikipedia.org

Chcesz dodać słowo, frazę lub tłumaczenie?

Wyślij nowe hasło.

Interfejs: Deutsch | Ελληνικά | English | Español | Français | Italiano | Polski | Português | Русский | Slovenščina | Srpski